windigipet.de
Win-Digipet - english forums => Win-Digipet Forum English => Thema gestartet von: Per Olsen am 21. Oktober 2007, 12:45:24
-
Hello.
From my "old" setup, I have laying around an unused Control Unit and an unused Control 80f from Maerklin. I am now using the Intellibox for my layout. The layout is now in need of a Booster. I think I have read somewhere that the Control Unit may be used as a booster together with the IB. Do you know if this is correct? In that case, how do I connect it?
This may be a bit off topic for this forum, but I think the expertice may be here..
Best regards,
Per.
-
Hallo Per
I've check the German Forum and I found some Information about that.
You can't use the 6021 Contol Unit as a Booster to drive the train in those combination.
All what you can do is.
You can use the Control Unit + Interface as a seperat Unit, to handle the Magnetic article (k83, K84 and so on)
that is possible in the Pro X Version.
What you should do is, to buy a seperat Booster for the IB. For example:
From here http://www.kc-modellbahntechnik.de/ (http://www.kc-modellbahntechnik.de/),
or here http://www.bmbtechnik.de/booster.html (http://www.bmbtechnik.de/booster.html),
or here http://www.heller-modellbahn.de/powerpack.htm (http://www.heller-modellbahn.de/powerpack.htm).
I hope it help you
Good luck
-
Hello !
Thank you very much ! I will look for a seperate booster, I think. I was sure I had read somewhere that it was possible to use an old control-unit as booster, but I must have been wrong. The boosters are very expensive in Norway, and importing it from another country is also expensive because of the VAT, customs etc.
Thank you any way !
Best regards,
Per.