Lost of connection beteween PC (WDP 2009.3 french ) and CS2

[Markus Herzog]

Hi Andre,

Have you now tryed the english 2009.4b?

Regards
Markus

[André Grandmaison]

Yes Markup,
but it's too early to conclude.

[André Grandmaison]

Hi Markus,
Since the last update, the trouble changed. Now as several train should run, one of them didn't start because theh start command wasn't done. Here are 4 panels, it never start and the control didn't get the alarm after delay was out. In that case the trouble is inside of wdp.
I think that situation is not easy to be determined, the came several time in a hours.

[Markus Herzog]

Hi Andre,

are you sure you used the correct contact numbers in the profile. The first contact number for starting the train in the profile is number 86. But the route is named 111>98? Which number is correct 111 or 86? Can you check this.

Regards
Markus

[André Grandmaison]

You are right, sorry
After have made a change on that train I forgot to delete the not used itinery.
Today the system was connected for more than 4 hours, without trouble.
This incident is to be closed

NB I notice that I edit any profile the Wdpupdu2.exe take 98% of load and need two minutes before give back the control to the main program.

Thanks and best rerards
André

[dconner]

Andrè, can you check the output of your CS power supply. Perhaps that is what is giving you problems ?

        Best Regards. Dave CONNER

[dconner]

Sorry, I did not see that this problem was closed. Dave CONNER