Märklin L 60883 with WINDIGIPET 2015

[JEANPIERRELELEUX]

HELLO
Sorry for my English who is not good but i try to explain my problem.
I have the new L 60883 Märklin and i have installed WDP 2015.
I even install the patch for Märklin L 60883 that MARKUS had developped at the beginning of the month of may.
It works very well for the BUS 0 and the BUS 1 ,but for the BUS 2 and the BUS 3 ,it doesn't work.
i think the problem become of that we have only 1984 possible contacts and for the BUS 2 we need the contact 2000 to 2496 and for the BUS 3 we need contact 3000 to 3496.
Somenone can confirm me this problem or is it possible to make it differently?

Thank you for you answer

best regards

JEAN PIERRE

[Markus Herzog]

Hello JEAN PIERRE,

no there is no problem, you just have to make a different configuration.

Win-Digipet can use up to 248 8-port-feedback modules, now lets count:
-contacts of L88 module no. in L88 1-2 -> 2 modules
-S88 contact at Bus 1 module no. in L88 126-187 -> 62 modules
-S88 contact at Bus 2 module no. in L88 251-312 -> 62 modules
-S88 contact at Bus 3 module no. in L88 376-437 -> 62 modules
In sum these are 188 feedback modules.

So if you really have 62 feedback modules per bus, you could config it in WDP like this:
-from module 1 to 2 WDP Start modul 1
-from module 126 to 187 WDP Start modul 3
-from module 251 to 312 WDP Start modul 65
-from module 376 to 437 WDP Start modul 127

By this you can map the usable module numbers of the L88 to any module numbers within WDP.

Regards
Markus

[JEANPIERRELELEUX]

Hello MARKUS,

Thank you very much for your fast answer.It's great.
I try your purpose and all is ok!

Thank you very much again 😀

I hope that it has been succesfull for someone else.

Best regards