Hello.
Normally I would check this myself on my layout, but I am not at home right now, so I cannot test it. But I am doing some work here on tours, routes and profiles. I have a question that goes like this:
When I make a profile automatically from a route, all events (start, stop, speed-changes etc) are transferred to the New profile. And if I later make changes in the profile, this Works fine. My question is this: If I remove some of the lines (say, speed-changes) from the profile (and NOT from the route), will they still be executed (from the route) ? So that commands that are in both the route and the corresponding profile, will be executed from the profile, and commands that are only in the route or only in the profile, will also be executed?
The reason for the question is to try to get rid of quite a lot of "Info"-Messages in "Check for errors for several editors/databases" that occur when using profiles on routes that ends in Intelligent Train Number Field. The error says that speed command in the ITND will be ignored. This is of course correct, but I would like to get rid of these Messages
anyway..
Best regards,
Per.
