Single cross give error in route and usage

[André Grandmaison]

Hi,
In X.3 English , the single cross give error. The route contains two invalid symbol !
Unfortunnately I could'nt add the image inside of this message! ( how know how to add image )
I have this message with two cross and 10 routes.

[Gerard Moggré]

Hello André,

Since you made this route, did you change something in your WDP railplan?, i.e. did you change some symbols?

Kind regards,
Gerard

[André Grandmaison]

Thanks,
I have rewrite all routes with invalid symbol, I will test soon
André

[André Grandmaison]

Hi Gerard, I have rewrite all route with error (exclamatuin mark) , all is ok now.
Except  at one place with 3 routes I still have the error "Add-on 1: Solenoid-symbol not in line with the track layaut" there is no exclamatuin mark, I have recreate those routes, withour success.
How is it possible to send the image with the trouble?
Best regards.
André

[Gerard Moggré]

Hi André,

Make a printscreen of the image, then open it in paint and put this image in a map (save as).
Then in answer a topic below, you see extra options. Over there open your map where this image is in and put this image (file) together with your answer.

[André Grandmaison]

Thanks,
Here are the last trouble in the track image.
I never use the oblique signal.
Thanks inforward
Andre

[Gerard Moggré]

Hello André,

Except  at one place with 3 routes I still have the error "Add-on 1: Solenoid-symbol not in line with the track layaut"

I assume you changed this symbol before, or not? And did you record this symbol in these 3 routes in the routes-editor as well?

Kind regards,
Gerard

[André Grandmaison]

Yes Gerard,
I have corrected those symbol several time ( two place with the same error) , and I never use the oblique symbol
best regards
André

[André Grandmaison]

trouble solved by moving the signal.
Thanks and regards
André