Logical mismatch in simulation mode in Tour automatic

[ebarra]

Hello,
When trying to test my logic conditions in simulation mode I get the following results (see picture attached).
The counter condition does not see the loc but the machine is there.
Nevertheless it seem to work in running mode (not very sure about that).
Is someone aware of this logic mismatch?
Is it only in simulation mode?
This also does not work with = or > conditions ( in simulation mode)?
Are the conditions working as shown in true mode?
This make it difficult to test conditions.
Regards.

[Stefan Lersch]

Hi,

is that contact shown red during simulation? It has to be occupied during simulation (red) otherwise it will not work properly.

[ebarra]

Hi Stefan,
Yes occupation is red during simulation.
I also tested on the layout in true conditions yesterday and same result:
I have to take the number to 0 to switch the condition to green.
Not logic.
Thanks.
Regards.