Which RMK to use ?

[Per Olsen]

Hello.

I am starting to work with Version 2015.  I am re-building the track layout in WDP to use one single 2-direction ITND in the middle of the stations.  In my old diagram I have 2 loco-signs, one for each direction,  In this new one, there will be only 1, for both directions.

Question:  Which RMK must I now assign to this one ?  Lets say that the station consists of 5 RMKs.  The one to the left and the one to the right is the stop-RMK for each direction.  Which one do I now use for the one sign that I now put in the middle of the station?

It is probably explained in the German manual, but I cannot figure it out.  Sorry..

Best regards,
Per.

[Bernd Senger]

Hi Per
Use one of the contacts in the middle. You have to change The  Start and Destination of the routes to the choosen contact. It's very important to configure the Feedback number in the correct order from the left  to the right or for the Top to the bottom within the itnd dialogue.

[Per Olsen]

Hello Bernd!

Thank you for Your answer.  Is it correct to say that I only put the order from left to right always, even though the Trains also will drive from right to left?  And it does not matter which one of the RMKs I use for the Train-icon? 

But then, when I modify each route, will they all have the same stop-RMK, no matter what direction the Train travels?  So the stop-RMK is always the same, even if the Train moves the opposite direction?

Best regards,
Per.