Train slowing down (inside a tour).

[Sven Spiegelhauer]

Hallo Per,

- Was zeigt die Zugüberwachung (F7)? Werden alle Fahrstraßen beendet?
- Was meldet das Lok-Control? Wird der Zug dort auch langsamer?

Entschuldige bitte, das ich auf deutsch antworte.

Fahre bitte einmal ohne Profile!

[Per Olsen]

Hello !

I do understand some German, so I could understand you

Yes, F7 shows that all Routes are ended as normal.
Yes, the Lok-Control does show that the lok reduces to 30 on RMK 108.

Yes, I have also tried without profiles, but still the same.

I must do something wrong, but I cannot see it...

Best regards,
Per.

[Sven Spiegelhauer]

Hallo Per,

ich kann keinen Fehler finden. Aber ändere bitte den Prüfkontakt in der Fahrstraße ID150 von 111 -> 109 und probiere es noch einmal aus.

[Per Olsen]

Hello again.

I did use 109 to start with, but changed to 111 to see if there was a change.  There was not, it is still the same.

Regards,
Per

[michael1957]

Hello Per,
I took a look at your routes. I have seen that you also have other routes that drive over these feedback contacts (routes with the numbers 39 to 42). On these routes you have also entered the contact 108 as a brake contact with 30 km / h. Have you ever tested whether the behavior of your trains on these routes is similar to that on route number 150?
Best regards from Austria, Michael

[Per Olsen]

Hello !

No, there has never been the same problem with those routes.  I tested again now, and they work as normal.  The trains do not brake at 108, just pass through at 70km/h.

But there is a difference, as my problem-tours start at one route earlier, and the route with 108 is the second route in the tour.  The routes you mention (39-42) all START with the route that passes by 108.  So I am convinced that my problems have something to do with the fact that the tours start one route before, and the route that slows down, is the second route in those tours.

I cannot see what I have done wrong.  It must be SOMETHING  

Best regards,
Per.

[Sven Spiegelhauer]

Hallo Per,

der Fehler liegt in der extrem hohen Stellungsrückmeldung der Signale. Insgesamt 11 Sekunden. Der Zug bremst, weil die nächste Fahrstraße noch nicht fertig gestellt ist. Erst nach 11 Sekunden wird wieder beschleunigt.

[Per Olsen]

Hello !

OK, I see.  It is too late for me to test today, but I will check tomorrow.  I am sure these values come from some kind of earlier testing, and I have not recognised it now.

Thank you very much for your help!  I am sure I will fix it now.  I will test tomorrow, and let you know.
Thanks again !

Best regards,
Per.

[Per Olsen]

Hello, Sven !

Problem is solved, THANK YOU!!! 

The reason I had these (rather big) values: 
A train travels along Tour, and it has to stop at a signal at the end of one of the Routes inside the Tour (because the next Route is not clear).  When the next Route becomes clear, I want the signal to turn green, and the train to wait a few moment before starting to move.  With "Stellungsrückmeldung" set to zero, sometimes the train starts to move at the moment (or even before) the signal has turned green.  That does not look very realistic

Now I changed them all to 1000ms, and tests now seem OK.  No reduction of speed on RMK 108.

Again, thank you for solving my problem !!!

Best regards,
Per.