Train will not start again, Inspektor says there is an active profile..

[Per Olsen]

Hello.

A strange thing happens here now, I must have done something wrong, as I did not have this problem before.  During Automatik-running, one train stops at a station, as normal.  But it does not start again.  Not untill I exit WDP and restarts it, then the train starts again.  The Inspektor says this:

Do 05:32:12
Anforderung: K583
Prüfe Fahrstraße: Nes3a>EspInH
Nach Ankunft: 00:00:00
Zug: BM6901 noch Profile aktiv! = EXIT

So I guess there should be some profile still active.  But I cannot see it.....!
Any ideas as to where I should look? 

I am certain this problem has arrived because of some mistake I have done, but I have now tried for many hours, and still cannot find it.  Sorry.

Best regards,
Per.

[Markus Herzog]

Hi Per,

Just press F7 to see in the inspector window and look which profile events are still active for this loco.

Regards
Markus

[Per Olsen]

Hello, Markus.

I tested a lot today....  It obviously has something to do with using Profiles.  I tried without, and no problem.  But with profiles, this happens.  I have searched everywhere in the profiles, but cannot see what I have done wrong.  I attach a screen-shot of the F7 window,  I do not understand what it means.  Maybe you can explain what I should be looking for?

Best regards,
Per.

[Markus Herzog]

Hi Per,

this means, that contact 584 and 583 of profile have non been executed (maybe because of an intelligent train number display and the destination of the route). Try to remove the two lines from the profile, because the train will already stop because of the intelligent train number display.
Maybe it is also sufficient to only remove the line regarding contact 584.

Regards
Markus

[Per Olsen]

Hello Markus.

Yes, I think you are right !  I noticed that longer trains work fine, but this very short train does not.  Probably because it does not reach the 2 contacts.  I was reading the sections on Intelligent train number for this, but did not find what I was searching for.  It is a big manual..

I will try this at home today, I am sure it works fine.

Thanks again, Markus, for excellent help !

Best regards,
Per.

[Per Olsen]

Hello again.

I have tested a bit now, and you are right.  I deleted those lines from the profile, then all was OK. 

Thank you !

Regards,
Per.