Lost feedback info since CS2 to 3.5.6

[André Grandmaison]

Hi,
This week-end I have updated my CS2, from 3.5.1 to 3.5.6 and I lost all feed-back information.
The restore 1.6.4 or 2.0.1 get again the feed-back. (other version not available on usb)
I have tested windipet 12 , and no feedback!
Is any one got this trouble?
Thanks in forward for any help.
André

[Markus Herzog]

Hello André,

do you have WDP 2012.2 update installed?

Regards
Markus

[André Grandmaison]

Thanks Markus,
I am in 11.5.230-32 and I have tested the last english demo version 12, whit the same trouble (no feedback showed s88)
Regards
Andre

[Stefan Lersch]

Hello André,

do you have feedbacks in the CS2? If there are no feedback shown in the CS2 than you can't have feedbacks in WDP.

[André Grandmaison]

Hi Markus,
The feedback are available on the CS2.
After your previous message, I have updated de demo version to 12.2 .
It's not easy, but this update give the feedback now on WDP.
I had send some informations on this trouble on CS2 forum and marklin service, without success.
With the update 12.2 in demo, the trouble is my be into the version 11.5.
What is the change in 12.2 to explain the correction?
What to do now?
Best regards
André

[Markus Herzog]

Hello André,

The answer is quite simple. Maerklin changed the protocol in their recent update and this new protocol functions are known to Win-Digipet since 2012.2. Until the recent update of the CS2 the CS2 supported the old and the new functions. Now they removed the old functions. They finished the back-compatibility.

Your only chance is to update to WDP 2012.2.

Regards
Markus

[André Grandmaison]

Thanks Markus.
I am surprised that I was the first to be impacted!
I think that everyone could buy the new version.
Thanks again and best regards.