I cannot find my error in the track-editor. Can you help me?

[Per Olsen]

Hello.

I am re-designing my old layout for WDP 2015.  So there are many un-finished parts, please ignore them...  But there is one error that I cannot figure out.  Look at my enclosed Project.  After leaving the track editor I always get the error-message that "Train number display (084,020) does need exactly 2 Connectors!".

Am I doing something wrong here?  What?

Best regards,
Per.

[Ralf Krapp]

Hello Per,
this  error-message will tell you, that you have to provide at the right and left side of the 3-field-train number display a single track symbol. When there is e.g. a Signal Symbol directly aside of the train number display, this will cause this error-message. Same Regulation is valid if the train number display is in vertical direction.
Hope this will help you.

[Per Olsen]

Hello Ralf!

Thank you for Your answer.

Well, I do of course know this, so I do have one single track section on each end of the 3-field Train number section.  So that should be OK.  I do have a track symbol 1 directly to the right of this, belonging to another track.  Does WDP think this is a Field that belongs to the same track as the 3-feld train number?  Could be...  The error-message disappeared when I replaced that 1-number With a single track....

Regards,
Per.

[Stefan Lersch]

Hello Per,

yes, that's exactly the reason. In your case it's not a mistake so you can ignore the message.

[Per Olsen]

Hello Stefan!

OK, that Clears it  So it is safe to ignore it.  I'll do just that.

Thank you !

Best regards,
Per.