ERROR Message VHD part of Intelligent Turntable

[Rupert van Swol]

Hello Forum,
I have a route (ID 208 ) that after activation the direction change command is NOT given to the Locomotive.
If I want to manually recreate the route 208 I get the message that the VHD is suddenly part of a turntable.
I just gave route 208 now another destination.
Then recreated a new route with the wizzard. That is route with ID 211.
And again, on this route ID 211 the locomotive does not turn around .
the reference to the turntable is the same.
The database repair allow does not give a solution.
The check function indicates 0 error .
Who can tell me what is happening?

kind regards
Rupert

[Markus Herzog]

Hello Rupert,

Upload a backup of your project with the message. Everything else is guessing.

Regards
Markus

[Rupert van Swol]

Hello Marcus , attached is the track file ( with the errors ) should you be interested in it.

The strange message and not wanting to turn is solved this morning. ( after a night's sleep )
The turning of the locomotive direction did not happen, as the direction arrows were missing in the VHD and a repair (film camera) gave the strange message that it was part of the TurnTable VHD.

This morning printed out the VHD summary list and went through it for errors. the printed list showed that there was no relationship between the VHD involved and the TurnTable VHD.

Considering it is a route-related fault
I then checked all routes in the Office mode of WDP , especially for the absence of direction arrows in the VHD . So that turned out to be more routes with missing direction arrows in the VHD
There were also routes with VHD and direction arrows outside the route.
These routes were all fixed .
Note
These routes with a VHD problem were all in the area where a modification was done with the addition of switches with thus an expansion of feedbacks in that area.
The affected routes where symbols had been missed and or disappeared were then also adjusted.

Even though the error lists did not contain any errors , the Database also underwent a repair . The manual checking of the routes proved to be necessary.

By the looks of it, the problem is now solved , I have run the DMU several times with no malfunctions.

[Markus Herzog]

Hello Rupert,

the error message is absolutly not strange about the message.
See at the screenshot.
I just opened the window of your "65 Ft Turntable" in edit mode. There I found that you entered contact number 56 as number of the VHD on your turntable. Then I looked at your track diagram and found this contact number within a station track. The correct number is maybe 49?

And because of this the message is absolutly not strange. And of course also because of this VHD have been excluded from the direction recording while automatic route creation.
I think you forgot to correct the contact number of the turntable VHD in this dialog when editing your track diagram.

Regards
Markus (Thanks for spelling my name correctly in the future)

[Rupert van Swol]

Hello Markus,
Thanks for finding the needle in the Haystack.
Yes then the message is also only logical , and I but searching for that feedback indicator.  Considering the feedback indicator of the bridge of the turntable was not the case.
Well at internal for the controls there is also a feedback detector.
Completely didn't think about it.
Will fix the error immediately.
many thanks for your help
Rupert