Problems with feedback contacts on wpd 2018

[geir]

Hi
I dont see any feedback from contacts.I have a cs3(not +). I use wdp 2018 and are a new to this program.All feedbaks works on cs3.When I took the picture the cs3 ,the contacts where yellow on cs3.I can operate the trains and turnouts from wdp.Atm , On cs3,I only have 1 Link 88 and and a S88 connected on Bus 1.The m83/84 works  fine

[geir]

The feedback works from link88.I changed the Nr to 2.But what number should the next S88 have?

[Bernd Senger]

Hi,
if the next modul is on the same bus (0) so behind the first module, you only have to increase the final modul in this bus to "modul 4"

[geir]

I only have 1 Link 88 and  a S88 connected on Bus 1 on the link 88.I dont get any feedback on s88 modul

[geir]

I,ve tryed to change "strang" .In my systemsetting/feedbackmodul,I have a field where I set "2",Thats the id from  my cs3 link88 setting.(It was a tip).With this setting L88 2Bus 0 ,all 16 contacts worked.The  s88 modul is connected to bus 1 on the link s88.I,m not able to get any feedback from it on wdp.It work on cs3.

[Markus Herzog]

Hi

If you have just connected one module with 16 ports to bus 1 you to select bus 1 from module 1 to module 2 WDP start module 3 (as you have selected start module 1 for the module at bus 0), but bus internally the counting for from and to always starts at 1 again

Regards
Markus

[geir]

Thanks alot,it works

[geir]

The third modul does not work.The fourt modul works fine but that one is on bus 2

[geir]

It's ok now